Jump to product information
1 from 8

Film cassette (Refill) 8x11 for Minox A, B, C & EC

Film cassette (Refill) 8x11 for Minox A, B, C & EC

Type
Normal price €29,95 EUR
Normal price Clearance €29,95 EUR
Set offer Sold Out
🟢 In stock · Including taxes. ✓ Free shipping within Germany

Sustainability pledge

All our products are made from PLA - a material derived from sugarcane and corn that is 100% biodegradable.

Learn more here.

Free shipping within Germany

With free shipping to your home in 2-3 days.

Learn more here.

30 Days Money Back Guarantee

You can test any product for 30 days. If you’re not satisfied, we’ll refund the full purchase price including shipping costs. No ifs, ands, or buts.

Learn more here.

  • Original Minox film no longer available? No problem. With this cassette, you can use any 35mm or 120 film – even cut down to 9.2 mm. Portra 400, HP5+, Tri-X, Delta 100 – whatever you want.
  • 10 times cheaper than NOS film. One roll of 35mm film yields up to 4 cassette loads. Instead of paying €30–50 for an old original cassette, you only pay the film price.
  • No scratches, proper film transport. Independently tested: The developed film shows clean negatives with even frame spacing – no scratches or transport issues.
  • Storage case included. Your exposed film is immediately protected from light.

Note on changing film

As with all Minox cassettes (including originals), the following applies:

  • Always change film in dim light – never in direct sunlight. Minox also recommends this in the original manual.
  • Place the cassette immediately after removal into the included storage case.
  • For highly sensitive films (ISO 800+), e.g. Delta 3200 or P3200, extra care is needed – these films are more sensitive to stray light.
  • Plan 2 blank exposures at the end of the film as a safety buffer.

Scope of delivery

  • 1x 4-piece film cassette for Minox 8x11
  • 1x light-tight storage case

Technical specifications

  • Material: PLA+ (technical plastic)
  • Color: Black
  • Required film width: 9.2 mm
  • Capacity: Max. 36 exposures (approx. 59 cm film length)
  • Construction: 4-piece (cassette body, spool body, 2 lids)

Description

This 4-piece cassette brings your Minox back into action – without relying on expensive and increasingly rare New-Old-Stock film. You can cut any 35mm or 120 film down to 9.2 mm width with a suitable film slitter and spool it yourself.

The cassette is precisely designed for 36 exposures. Important: Do not try to load longer films (e.g. 50 exposures) – the mechanical tolerances of Minox cameras are not designed for that.

Detailed instructions for cutting and loading film can be found at moments-of-now.com.

Compatibility

  • Minox A, B, BL, C, EC – fully compatible
  • Minox LX, TLX, CLX, MX – fully compatible (cassette supports automatic frame counter reset)
  • Sharan – compatible
  • Ataron – compatible
  • VEF RigaNot recommended. Cassette can be inserted with pressure, but removal is problematic – attached lids may remain inside the camera. Depends on the individual camera condition.

Field test: Results from the community

An experienced Minox photographer tested this cassette in a Minox A with ISO 200 film and had the results developed in a professional lab. Three points were checked:

  • Light tightness: No problems in dim light (as recommended by Minox). Under intentional extreme exposure (EV 15, direct midday sun), minimal light leakage appears at the film end – not relevant with proper handling.
  • Film transport: Even negative spacing, no increased resistance.
  • Scratches: No scratches on the developed film.

Note: Results may vary depending on camera condition, film type, and handling. We recommend always changing film in dim light.

Developed test strip from a Minox A – correct frame spacing

Developed test strip – even frame spacing, no scratches. Photo: Thomas Siepmann

Part of the Minox 8x11 Subminiature System

This product is part of our Minox 8x11 ecosystem: cut film, load cassette, develop, and scan — all from one source.

SKU: 1522b Show complete details

We are Anto & Vladi

Support a young startup

You want clever solutions instead of mass-produced goods? With us, you don’t buy from an anonymous wholesaler, but directly from the founders. We (Anto & Vladi) started our startup in 2021 in Würzburg to help you bring analogue photography back to life.

Developed by engineers

Quality made in Germany

We do not sell anything we would not use ourselves. We are engineers and camera enthusiasts, and we know that precision is especially important in camera technology. That is why every single part is designed and thoroughly tested by us here in Würzburg.

From Germany to the whole world

Fast DHL shipping

You don’t want to wait forever for your item? Every article is personally made fresh for you by us in Würzburg on the day of your order, checked, packed, and sent worldwide. As soon as you have ordered, your package is almost on its way to you with the fastest shipping options from DHL and Deutsche Post.